LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> SX4 LE, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Differential Assembly) >> Diagnostic Information and Procedures >> DTC Clearance
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Clearance

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to OFF position.
  2. Connect SUZUKI scan tool to DLC (1) located on underside of instrument panel.

    Special Tool 

    (A): SUZUKI scan tool (SUZUKI-SDT) 

    Fig 1: Connecting Suzuki Scan Tool To DLC
    G06868321Courtesy of SUZUKI OF AMERICA CORP.
  3. Turn ignition switch to ON position.
  4. Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operators manual for further details.
  5. After completing clearance, turn ignition switch OFF and disconnect SUZUKI scan tool from DLC.
    NOTE: DTC stored in 4WD control module memory are also cleared in the following cases. Be careful not to clear them before keeping their record.
    • When power to 4WD control module is cut off (by disconnecting battery cable, removing fuse or disconnecting 4WD control module connectors).
    • When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles.
scientia non olet · About LEMON Manuals