Front Disc Brake Pad Removal and Installation: Installation

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.

Reference: FRONT DISC BRAKE PAD INSPECTION

Reference: FRONT DISC BRAKE CALIPER CHECK

Apply small amount of pad grease "a" (included in spare parts) to pad spring and set brake pad spring as shown in figure.

Fig 1: Identifying Pad Spring And Set Brake Pad Spring
Courtesy of SUZUKI OF AMERICA CORP.
Set brake pad springs (1), and install brake pads (2), shims (4) and shim cover (5).
NOTE: Install the brake pad with wear indicator (3) to the vehicle center side of front right brake pad.

Fig 2: Installing Brake Pads, Shims And Shim Cover
Courtesy of SUZUKI OF AMERICA CORP.
Install caliper and tighten caliper pin bolts to specified torque.
Tightening torque

Caliper pin bolt (a): 26 N.m (2.6 kg-m, 19.0 lbf-ft)

Fig 3: Installing Caliper And Tighten Caliper Pin Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install front wheel referring to WHEEL (WITH TIRE) REMOVAL AND INSTALLATION .
Check brake effectiveness.