Valve Body Assembly Removal and Installation: Removal

Remove CVT oil pan and oil strainer. See CVT Oil Pan and Oil Strainer Removal and Installation .
Disconnect ROM connector (1), solenoid connector (3) and remove wire harness clamp (2).
Remove solenoid harness fastening bolt (4), if necessary.

Fig 1: Identifying ROM Connector, Solenoid Connector, Wire Harness Clamp & Fastening Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Remove oil strainer bracket (1) from valve body by removing bolts.

Fig 2: Identifying Oil Strainer Bracket
Courtesy of SUZUKI OF AMERICA CORP.
Remove manual valve lever (1) by removing nut (2) and spring washer (3).

Fig 3: Identifying Manual Valve Lever, Nut & Spring Washer
Courtesy of SUZUKI OF AMERICA CORP.
Remove spacer (1) from valve body.

Fig 4: Identifying Valve Body Spacer
Courtesy of SUZUKI OF AMERICA CORP.
Remove valve body assembly according to the following procedure.
1. Insert a pin (1) (3 mm dia.) through linkage stopper hole (2) in order to retain pulley ratio linkage.
  
  Fig 5: Inserting Pin Through Linkage Stopper Hole
  Courtesy of SUZUKI OF AMERICA CORP.
2. Remove valve body bolts (1) and (2).
  
  Fig 6: Identifying Valve Body Bolts
  Courtesy of SUZUKI OF AMERICA CORP.
3. Remove valve body assembly (1) from transmission case.
  NOTE: Keep the pin inserted at step a) as it is while removing the valve body.
  
  Fig 7: Identifying Valve Body Assembly
  Courtesy of SUZUKI OF AMERICA CORP.
Remove lip seal (1) from transmission case.

Fig 8: Identifying Transmission Case Lip Seal
Courtesy of SUZUKI OF AMERICA CORP.
Remove solenoid harness from transmission case, if necessary.