P/S Pump Removal and Installation: Installation

Reverse removal procedure, and then nothing the following instructions.

NOTE:

When installing P/S pump high pressure pipe union bolt to P/S pump, be sure to use new washer.
Fill specified power steering fluid after installation and bleed air without failure referring to P/S SYSTEM AIR BLEEDING PROCEDURE: HYDRAULIC TYPE .

Tightening torque

P/S pump mounting bolt: 25 N.m (2.5 kg-m, 18.5 lbf-ft)

P/S pump high pressure pipe union bolt: 65 N.m (6.6 kg-m, 48.0 lbf-ft)