LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> SX4 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC Clearance >> Pending and Confirmed DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pending and Confirmed DTC

WARNING: This page is about a different variant/trim than selected.
  1. Connect CAN communication OBD generic scan tool or SUZUKI scan tool to DLC. See DTC Check .
  2. Turn ignition switch to ON position.
  3. Erase DTC and pending DTC according to instructions displayed on scan tool. Refer to scan tool operators manual for further details.

    If communication between scan tool and TCM is not possible, go to TROUBLESHOOTING FOR COMMUNICATION ERROR WITH SCAN TOOL USING CAN .

  4. After completing the clearance, turn ignition switch OFF and disconnect scan tool from DLC.
    NOTE: Pending and confirmed DTC and freeze frame data stored in TCM memory are also cleared in the following cases. Be careful not to clear them before keeping their record.
    • When power to TCM is cut off (by disconnecting battery cable, removing fuse or disconnecting TCM connectors).
    • When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles.
    • Even though the pending and confirmed DTCs are cleared, the permanent DTC will not be cleared.
scientia non olet · About LEMON Manuals