P/S Pump Removal and Installation: Installation

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.

Reverse removal procedure, and then nothing the following instructions.

NOTE:

When installing P/S pump high pressure pipe union bolt to P/S pump, be sure to use new washer.
Fill specified power steering fluid after installation and bleed air without failure referring to P/S SYSTEM AIR BLEEDING PROCEDURE: HYDRAULIC TYPE .

Tightening torque

P/S pump mounting bolt: 25 N.m (2.5 kg-m, 18.5 lbf-ft)

P/S pump high pressure pipe union bolt: 65 N.m (6.6 kg-m, 48.0 lbf-ft)