Front Wheel Speed Sensor Removal and Installation: Installation

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.

Reference: FRONT AND REAR WHEEL SPEED SENSOR INSPECTION

Check that no foreign material is attached to sensor (1) and wheel speed sensor encoder (included in wheel hub assembly).
Install it by reversing removal procedure.
NOTE: Before fitting wheel speed sensor, be sure to silicon grease to its O-ring.

Tightening torque

Front wheel speed sensor bolt (a): 11 N.m (1.1 kg-m, 8.0 lbf-ft)

Front wheel speed sensor harness clamp bolt (b): 11 N.m (1.1 kg-m, 8.0 lbf-ft)

Fig 1: Identifying Front Wheel Speed Sensor Harness Clamp Bolt And Front Wheel Speed Sensor Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Check that there is no clearance between sensor (1) and knuckle.

Fig 2: Checking Clearance Between Sensor And Knuckle
Courtesy of SUZUKI OF AMERICA CORP.