LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> SX4 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Engine General Information And Diagnosis) >> Diagnostic Information and Procedures >> DTC P0602: Control Module Programming Error >> DTC Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Troubleshooting

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC INFORMATION AND PROCEDURES REFERENCE CHART

Step Action YES NO
1  DTC recheck 
  1. Clear DTC. Refer to DTC CLEARANCE .
  2. Turn OFF ignition switch.
  3. Perform DTC confirmation procedure, and check DTC.

Is DTC P0602 still detected? 		 Go to Step 2. Check for intermittent trouble. INTERMITTENT AND POOR CONNECTION INSPECTION
2  ECM reprogramming check 
Was reprogramming of ECM executed? 		 Execute reprogramming of ECM correctly once again. Go to Step 3.
3  ECM power and ground circuit check 
  1. Check ECM power and ground circuit. Refer to ECM Power and Ground Circuit Check .

Is it in good condition? 		 Repair or replace defective wire harness. Substitute a known-good ECM and recheck DTC
scientia non olet · About LEMON Manuals