Engine Flywheel Installation

Reference: ENGINE FLYWHEEL CLEANING AND INSPECTION .

Special Tool 

EN 46106 Engine Flywheel Holding Tool 

J 45059 Angle Meter 

Fig 1: Identifying Engine Flywheel

Courtesy of SUZUKI OF AMERICA CORP.

1. Place the engine flywheel in position on the crankshaft.
   Fig 2: Identifying Engine Flywheel Bolts

   Courtesy of SUZUKI OF AMERICA CORP.
2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.
   Fig 3: Identifying Special Tool (EN 46106)

   Courtesy of SUZUKI OF AMERICA CORP.
3. Install the EN 46106.
   Fig 4: Identifying Engine Flywheel Bolts

   Courtesy of SUZUKI OF AMERICA CORP.
   CAUTION: Refer to FASTENER NOTICE .
4. Install the remaining NEW engine flywheel bolts.

   Tightening torque 

   1. Tighten the NEW engine flywheel bolts to 30 N.m (22 lb ft)  .
   2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the J 45059  .

   Reference: CRANKSHAFT BALANCER INSTALLATION ].