DTC Check

Confirm that ignition mode of keyless push start system is in "OFF".
Connect SUZUKI scan tool to DLC (1) located around bottom at driver's seat side.
Special Tool
1. SUZUKI scan tool (SUZUKI-SDT)
Fig 1: Connecting Scan Tool To DLC
Courtesy of SUZUKI OF AMERICA CORP.
Start engine.
Read DTC according to instructions displayed on SUZUKI scan tool and print them or write them down.
NOTE:
If communication between SUZUKI scan tool and P/S control module is not possible, check related items according to the following points for recovery.
- SUZUKI scan tool and communication cable
- DLC power circuit and ground circuit
- CAN communication system malfunction (Control Module Communication Bus "Off" is detected in any control module)
Push engine switch to change ignition mode of keyless push start system to "OFF" and disconnect SUZUKI scan tool from DLC after completing check.