LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> Kizashi S, 4WD >> Repair and Diagnosis >> Engine Performance >> System >> Engine General Information & Diagnosis >> Diagnostic Information and Procedures >> Engine and Emission Control System Check >> Notes
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine and Emission Control System Check: Notes

DIAGNOSTIC PROCEDURES CHART

Step Action YES NO
1  Customer complaint analysis, see  Step 1  . 
  1. Perform customer complaint analysis.

Was customer complaint analysis performed? 		 Go to Step 2. Perform customer complaint analysis.
2  DTC/freeze frame data check, record and clearance, see  Step 2  . 
  1. Check for DTC (current and pending DTC).

Is there any DTC(s)? 		 Print DTC and freeze frame data or write them down and clear them by referring to DTC CLEARANCE , and go to Step 3. Go to Step 4.
3  Visual inspection, see  Step 3 and 4: Visual Inspection  . 
  1. Perform visual inspection.

Is there any faulty condition? 		 Repair or replace faulty part, and go to Step 11. Go to Step 5.
4  Visual inspection, see  Step 3 and 4: Visual Inspection  . 
  1. Perform visual inspection.

Is there any faulty condition? 		 Repair or replace faulty part, and go to Step 11. Go to Step 8.
5  Trouble symptom confirmation  , see Step 5: Trouble Symptom Confirmation .
  1. Confirm trouble symptom.

Is trouble symptom identified? 		 Go to Step 6. Go to Step 7.
6  Rechecking and recording DTC/freeze frame data  , see Step 6 and 7 .
  1. Recheck for DTC (current and pending DTC) and freeze frame data.

Is there any DTC(s)? 		 Go to Step 9. Go to Step 8.
7  Rechecking and recording DTC/freeze frame data  , see Step 6 and 7 .
  1. Recheck for DTC (current and pending DTC) and freeze frame data.

Is there any DTC(s)? 		 Go to Step 9. Go to Step 10.
8  Engine basic inspection and engine symptom diagnosis  , see Step 8: Engine Basic Inspection and Engine Symptom Diagnosis .
  1. Perform engine basic inspection and engine symptom diagnosis.

Is there any faulty condition? 		 Check and repair faulty part(s), and go to Step 11. Go to Step 10.
9  Troubleshooting for DTC  , see Step 9 .
  1. Perform troubleshooting for applicable DTC.

Are check and repair complete? 		 Go to Step 11. Check and repair faulty part(s), and go to Step 11.
10  Intermittent problem check  , see Step 10: Intermittent Problem Check .
  1. Check for intermittent problems by referring to "INTERMITTENT PROBLEM CHECK ".

Is there any faulty condition? 		 Repair or replace faulty part(s), and go to Step 11. Go to Step 11.
11  Final confirmation test  , see Step 11: Final Confirmation Test .
  1. Perform final confirmation test.

Is there any problem symptom, DTC or abnormal condition? 		 Go to Step 6. End.
scientia non olet · About LEMON Manuals