Stator and Rectifier

Using ohmmeter (1), check continuity between all pairs of leads (2) and (3).
If there is no continuity, replace stator.

Fig 1: Checking Continuity Between All Pairs Of Leads
Courtesy of SUZUKI OF AMERICA CORP.
Using ohmmeter (1), check continuity between the following terminals.
- "B" terminal (2) and each coil lead (4)
- Ground (3) and each coil lead (4).
Switch the positive (+) side prove and negative (-) side and measure to check continuity in both polarity directions.

If there is continuity in only one polarity direction, stator coil is normal.

If there is no continuity with either polarity or there is continuity with both polarities, replace stator.

Fig 2: Checking Continuity Between B Terminal And Each Coil Lead
Courtesy of SUZUKI OF AMERICA CORP.