Rear Wheel Speed Sensor Removal and Installation

Rear Wheel Speed Sensor Removal and Installation

Front and Rear Wheel Speed Sensor On-Vehicle Inspection

NOTE:

Failure to take proper precautions when removing and installing the wheel speed sensor may lead to damaged to the wheel speed sensor harness.

Do not pull on or twist the wire harness when removing and installing the sensor.

Removal

1) Disconnect negative (-) cable at battery.
2) Hoist vehicle a little and remove wheel.
3) Disconnect rear wheel speed sensor connector (1).
4) Remove rear wheel speed sensor bracket bolt (2) and wheel speed sensor bolt (3).
5) Remove rear wheel speed sensor (4) from suspension knuckle.






Installation

Front and Rear Wheel Speed Sensor Inspection

Reverse removal procedure, noting the following points.

- Check detective area is not covered with iron powder.
- Tighten rear wheel speed sensor bolt (1) and rear wheel speed sensor bracket bolt (2) to specified torque.

Tightening torque
Rear wheel speed sensor bolt (a): 11 Nm (110 kgf-m, 8.5 lbf-ft)
Rear wheel speed sensor bracket bolt (b): 25 Nm (250 kgf-m, 18.5 lbf-ft)

- Confirm that there is no space between rear wheel speed sensor (3) and suspension knuckle (4).
















- Install wheel. Removal and Replacement