Scan Tool Testing and Procedures

Scan Tool Data


Keyless Start Control Module


Parameter data below are values measured with scan tool when vehicle operates normally.
1) Confirm that ignition mode of keyless push start system is in "OFF".
2) Connect SUZUKI scan tool to DLC.
3) Adjust each tire pressure to 260 kPa.
4) Drive vehicle at 35 km/h (22 mph) for 10 minutes or more.
5) Stop vehicle.
6) Apply parking brake and block wheels.
7) Push engine switch to change ignition mode to "ON".
8) Confirm that no DTC is detected.






NOTE:
Each tire pressure sensor is numbered and that number is assigned in the order as its ID code is registered in keyless start control module. It does not indicate tire position (front-left, front-right, rear-left and rear-right). Check what number of tire pressure sensor is assigned to which tire, referring to How to Identify Tire Pressure Sensor Number How to Identify Tire Pressure Sensor Number.