Enabling Air Bag System

Enabling Air Bag System

1) Make sure that removed components are installed and/or disconnected connectors are connected properly.
2) Check that ignition mode is in "OFF".
3) Connect negative (-) cable at battery and/or install "A/B" fuse to junction block. Precautions for Disposal of Air Bag and Seat Belt Pretensioner
4) Push engine switch to change ignition mode to "ON".
5) Check if "AIR BAG" warning light flashes for about 6 seconds and then comes off.
6) Perform Air Bag System Construction Air Bag System Construction
if defective.