Flow test description
- Step 1: Check "AIR BAG" warning light and circuits .
- Step 2: Check that "AIR BAG" warning light lights .
- Step 3: Check that "AIR BAG" warning light flashes 6 times after ignition switch is turned ON .
- Step 4: Check that history code(s) is in SDM memory .
- Step 5: Check that current code is in SDM memory .
| Step | Action | Yes | No |
|---|---|---|---|
| 1 |
Does "AIR BAG" warning light come ON when ignition switch is turned ON? |
Go to Step 2. | Proceed to "AIR BAG" WARNING LIGHT DOES NOT COME ON . |
| 2 | Does "AIR BAG" warning light come ON steady? | Proceed to "AIR BAG" WARNING LIGHT COMES ON STEADY . | Go to Step 3. |
| 3 | Does "AIR BAG" warning light turn OFF, after flashing 6 times? | "AIR BAG" warning light circuit is in good condition. Go to Step 4. | "AIR BAG" warning light circuit is not in good condition. Go to Step 5. |
| 4 | Check DTC referring to DTC CHECK
. Is "NO CODES" displayed on SUZUKI scan tool? |
Air bag system is in good condition. | An intermittent trouble has occurred at some place. Check the connector harness, etc. related to the sensed DTC. Refer to INSPECTION OF INTERMITTENT AND POOR CONNECTIONS . Then clear DTC (referring to DTC CLEARANCE .) and repeat this flow. |
| 5 | Check DTC referring to DTC CHECK
. Is "NO CODES" displayed on SUZUKI scan tool? |
Substitute a known-good SDM and recheck. | Check and repair according to flow corresponding to that DTC. |