DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.

Step	Action	Yes	No
1	Was "A/T System Check" performed?	Go to Step 2.	Go to A/T SYSTEM CHECK .
2	Check output shaft speed sensor circuit Disconnect TCM connectors with ignition switch OFF. Check for proper connection to output shaft speed sensor at "E93-5" and "E93-14" terminals. If OK, check resistance of sensor circuit. Resistance of output shaft speed sensor circuit Between terminals "E93-5" and "E93-14" of disconnected harness side TCM connector: 560 - 680 Ω at 20 °C (68 °F) Between terminals "E93-14" of disconnected harness side TCM connector and ground: No continuity Are check results satisfactory?	Go to Step 4.	Go to Step 3.
3	Check output shaft speed sensor Check output shaft speed sensor referring to OUTPUT SHAFT SPEED SENSOR INSPECTION . Is check result satisfactory?	Output shaft speed sensor circuit is malfunction.	Go to Step 4.
4	Check visually output shaft speed sensor and sensor rotor using mirror for following No damage No foreign material attached Correct installation Fig 1: Locating Output Shaft Speed Sensor And Sensor Rotor Inspection Point Are they in good condition?	Intermittent trouble. Check for intermittent trouble referring to INTERMITTENT AND POOR CONNECTION INSPECTION .	Clean, repair or replace.