DTC Clearance
WARNING:
If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.
- Select a level road with no traffic to minimize the risk of accident
- Perform the test extremely carefully.
- Perform the road test using 2 persons, a driver and an assistant.
After repair or replace malfunction part(s), clear all DTCs by performing the following procedure or using SUZUKI scan tool.
- Connect SUZUKI scan tool to DLC in the same manner as when making this connection for DTC check.
- Turn ignition switch to ON position.
- Erase DTC according to instructions displayed on scan tool. Refer to
scan tool operator's manual for further details.NOTE: For DTC C1022, C1026, C1032, C1036 and C1061, confirm that ABS warning light turns off after performing Step 2 of "Test Driving" under Electronic Stability Program Check , and then clear the DTCs.
- After completing the clearance, turn ignition switch OFF and disconnect scan tool from DLC.
- Perform "Driving Test" (Step 2 of Electronic Stability Program Check ) and DTC Check and confirm that NO DTC is displayed on scan tool.