With SDT

TESTING CONDITION

• For best results, perform at ambient temperature of -10°C (14°F) or higher. 
• For best results, perform at engine coolant temperature of -10°C (14°F) to 52°C (126°F). 
• Before performing the following procedure, do not add fuel. 

1. Turn A/C switch OFF.
2. Turn blower fan switch OFF.
3. Turn ignition switch ON.
4. Select "COOLAN TEMP/S" in "Data list" mode with SDT.
5. Check the indication of "COOLAN TEMP/S". If it is below 52°C (126°F), go to following step. If it is above 52°C (126°F), cool down the engine to less than 52°C (126°F). Then go to next steps.
6. Start engine and wait at idle for at least 10 minutes under the following conditions.

   VHCL SPEED SE

   More than 56 km/h (35MPH)

   CAUTION: Always drive vehicle at a safe speed.

   NOTE: If "COOLANT TEMP/S" increases to more than 71°C (160°F) within 30 minutes, turn ignition switch OFF because the test result will be OK.

7. Check 1st trip DTC.
8. If 1st trip DTC is detected, go to Diagnosis Procedure .