DTC Confirmation Procedure
DIAGNOSIS PROCEDURE CHART
| Step |
Action |
YES |
NO |
| 1 |
INSPECTION START
Is it necessary to erase permanent DTC? |
GO TO 3. |
GO TO 2. |
| 2 |
PERFORM COMPONENT FUNCTION CHECK
Perform component function check. Refer to Component Function Check .
Is the inspection result normal? |
INSPECTION END |
Proceed to Diagnosis Procedure . |
| 3 |
PRECONDITIONING
If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
- Before performing the following procedure, do not add fuel.
- Before performing the following procedure, check that fuel level is between 1/4 and 4/4.
- Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.
|
GO TO 4. |
|
| 4 |
PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and let it idle for 60 minutes.
- Move the vehicle to a cool place.
NOTE:
Cool the vehicle in an environment of ambient air temperature between -10°C (14°F) and 35°C (95°F).
- Turn ignition switch OFF and soak the vehicle for 12 hours.
CAUTION:
Never turn ignition switch ON during soaking.
NOTE:
The vehicle must be cooled with the food open.
- Start engine and let it idle for 5 minutes or more.
CAUTION:
Never turn ignition switch OFF during idling.
- Check 1st trip DTC.
Is 1st trip DTC detected? |
Proceed to Diagnosis Procedure . |
INSPECTION END |