Transmission Assembly: Removal and Installation for VQ40DE 2WD Models: Installation

Installation of the remaining components is in the reverse order of the removal, while paying attention to the following work.

• When installing transmission to the engine, tighten the bolts to the specified torque using sequence shown.
  Fig 1: Identifying Transmission Cover Bolts Tightening Sequence

  Courtesy of SUZUKI OF AMERICA CORP.

  Transmission bolts: 75 N.m (7.6 kg-m, 55 ft-lb) 

• Align the positions of bolts for drive plate with those of the torque converter, and temporarily tighten the bolts. Then, tighten the bolts with the specified torque.
  Fig 2: Identifying Drive Plate Bolts

  Courtesy of SUZUKI OF AMERICA CORP.
  CAUTION:

  • When turning crankshaft, turn it clockwise as viewed from the front of the engine.
  • After converter is installed to drive plate, rotate crankshaft several turns and check to be sure that transmission rotates freely without binding.
  • When replacing an engine or transmission you must make sure the dowels are installed correctly during re-assembly.
  • Improper alignment caused by missing dowels may cause vibration, oil leaks or breakage of drive train components.
• Install crankshaft position sensor (POS).
• After completing installation, check fluid leakage, fluid level, and the positions of A/T. Refer to [CHECKING THE A/T FLUID (ATF) ], [SHIFT CONTROL SYSTEM: INSPECTION AND ADJUSTMENT ].