Side Curtain Air Bag Module: Removal and Installation: Removal

NOTE: Crew cab model shown, king cab similar

CAUTION:

Do not attempt to repair or replace damaged direct-connect SRS component connectors. If a direct-connect harness connector is damaged, the harness must be replaced.
Before servicing the SRS, turn the ignition switch off, disconnect both battery terminals and wait at least three minutes.
When servicing the SRS, do not work from directly in front of air bag module.

Remove headlining. Refer to [HEADLINING: REMOVAL AND INSTALLATION ]
Disconnect front and rear side curtain air bag module connectors.
- For removal/installation of the direct-connect SRS connectors, refer to [DIRECT-CONNECT SRS COMPONENT CONNECTORS DESCRIPTION ].
Remove the bolts in order starting at the front or rear, and remove the side curtain air bag module.
CAUTION:
- When servicing the SRS, do not work from directly in front of air bag module.
- Do not insert any foreign objects (screwdriver, etc.) into air bag module or harness connectors.
- Do not disassemble air bag module.
- Do not expose the air bag module to temperatures exceeding 90°C (194°F).
- Replace side curtain air bag module if it has been dropped or sustained an impact.
  
  Fig 1: Caution For Air Bag Module Handling
  Courtesy of SUZUKI OF AMERICA CORP.
- Do not allow oil, grease or water to come in contact with the air bag module.