Connecting Rod Diameter (Big End)

WARNING: This page is about a different variant/trim than selected.

Install connecting rod bearing cap without installing connecting rod bearing, and tightening connecting rod bolts to the specified torque. Refer to [ENGINE UNIT: DISASSEMBLY AND ASSEMBLY ] for the tightening procedure.

Fig 1: Identifying Connecting Rod Diameter (Big End)
Courtesy of SUZUKI OF AMERICA CORP.
Measure the inner diameter of connecting rod big end with inside micrometer.
Standard: 57.000 - 57.013 mm (2.2441 - 2.2446 in)
If out of the standard, replace connecting rod assembly.