ASCD Clutch Switch

WARNING: This page is about a different variant/trim than selected.

Check harness continuity between ASCD clutch switch terminals 1 and 2 under the following conditions.

Fig 1: Checking Harness Continuity Between ASCD Clutch Switch Terminals 1 And 2

Courtesy of SUZUKI OF AMERICA CORP.

CONTINUITY SPECIFICATION

Condition	Continuity
Clutch pedal: Fully released	Should exist
Clutch pedal: Slightly depressed	Should not exist

If NG, adjust ASCD clutch switch installation, refer to [CLUTCH PEDAL: ON-VEHICLE INSPECTION AND ADJUSTMENT ], and perform step 3) again.