Diagnostic Procedure
WARNING: This page is about a different variant/trim than selected.
DIAGNOSTIC PROCEDURE
| Step |
Action |
YES |
NO |
| 1 |
CHECK O/D OFF INDICATOR LAMP
- Start the engine with selector lever in "P" position. Warm engine to normal operating temperature.
- Turn ignition switch ON and OFF at least twice, then leave it in the OFF position.
- Wait 10 seconds.
- Turn ignition switch ON. (Do not start engine.)
Does O/D OFF indicator lamp come on for about 2 seconds? |
GO TO 2. |
GO TO Symptom Chart
. |
| 2 |
JUDGEMENT PROCEDURE STEP 1
- Turn ignition switch OFF.
- Keep pressing shift lock release button.
- Move selector lever from "P" to "D" position.
- Release accelerator pedal. (Set the closed throttle position signal "ON".)
- Depress brake pedal. (Stop lamp switch signal "ON".)
- Turn ignition switch ON. (Do not start engine.)
- Wait 3 seconds.
- Move the selector lever from "D" to "3" position.
- Release brake pedal. (Stop lamp switch signal "OFF".)
- Move the selector lever from "3" to "2" position.
- Depress brake pedal. (Stop lamp switch signal "ON".)
- Depress accelerator pedal fully and release it.
|
GO TO 3. |
|
| 3 |
CHECK SELF-DIAGNOSIS CODE Check O/D OFF indicator lamp. Refer to "JUDGEMENT SELF-DIAGNOSIS CODE ". If the system does not go into self-diagnostics. Refer to
DTC P0705 PARK/NEUTRAL POSITION SWITCH ,
CLOSED THROTTLE POSITION AND WIDE OPEN THROTTLE POSITION CIRCUIT CHECK ,
BRAKE SIGNAL CIRCUIT CHECK . |
DIAGNOSIS END |
|