Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Position the stabilizer shaft in the vehicle, while positioning the links to the stabilizer bar.
Install the stabilizer shaft clamps and bushings to the stabilizer shaft.

Fig 1: Identifying Stabilizer Shaft Clamp Bolts (2 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: Refer to FASTENER NOTICE .
Install the stabilizer shaft clamp bolts.
Tightening torque

Tighten the bolts to 70 N.m (52 lb ft).

Fig 2: Identifying Stabilizer Link To Stabilizer Shaft Nut
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: Hold the ball shaft secure with a TORX® bit, when installing the nut.
Install the stabilizer link to stabilizer shaft nut.
Tightening torque

Tighten the nut to 50 N.m (37 lb ft).
Install the rear suspension support. Refer to INSTALLATION PROCEDURE and INSTALLATION PROCEDURE .
Install the spare tire to the vehicle.
Lower the vehicle.