Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Position the stabilizer link through the lower control arm.

Fig 1: Identifying Stabilizer Link To Lower Control Arm Nut (2 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.

CAUTION: Refer to FASTENER NOTICE .

NOTE: When connecting the stabilizer link, hold the link with a wrench to prevent turning.
Install the stabilizer link to lower control arm nut.
Tightening torque

Tighten the nut to 15 N.m (11 lb ft).

Fig 2: Identifying Stabilizer Link To Stabilizer Shaft Nut
Courtesy of SUZUKI OF AMERICA CORP.

NOTE: Hold the ball shaft secure with a TORX® bit, when installing the nut.
Install the stabilizer link to stabilizer shaft nut.
Tightening torque

Tighten the nut to 50 N.m (37 lb ft).

Fig 3: Identifying Stabilizer Shaft Clamp Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Tighten the loose stabilizer shaft clamp bolts.
Tightening torque

Tighten the bolts to 70 N.m (52 lb ft).
Install the rear tire and wheel assembly. Refer to INSTALLATION PROCEDURE .
Lower the vehicle.