LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Power Assisted Steering System) >> Repair Instructions >> Power Steering Fluid Reservoir Outlet Hose Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the power steering reservoir outlet hose to the vehicle.
    Fig 1: Identifying Power Steering Reservoir Outlet Hose Clamp & Power Steering Reservoir Outlet Hose (3 Of 4)
    G04844019Courtesy of SUZUKI OF AMERICA CORP.
  2. Compress the power steering reservoir outlet hose clamp (1) and connect the power steering reservoir outlet hose (2) to the power steering pump.
    Fig 2: Identifying Power Steering Reservoir Outlet Hose Clamp & Power Steering Reservoir Outlet Hose (4 Of 4)
    G04844020Courtesy of SUZUKI OF AMERICA CORP.
  3. Compress the power steering reservoir outlet hose clamp (1) and connect the power steering reservoir outlet hose (2) to the remote power steering fluid reservoir.
  4. Clean any excess power steering fluid from the vehicle and remove the drain pans.
  5. Install the right side engine splash shield. Refer to ENGINE SPLASH SHIELD REPLACEMENT - RIGHT SIDE .
  6. Install the fuel injector sight shield. Refer to INSTALLATION PROCEDURE .
  7. Fill and bleed the power steering system. Refer to POWER STEERING SYSTEM BLEEDING .
scientia non olet · About LEMON Manuals