Connecting Rod Bearing Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Special Tool (EN 46121)

Courtesy of SUZUKI OF AMERICA CORP.

NOTE: If the connecting rod bearings have been used in a running engine, you must replace them with NEW connecting rod bearings for reassembly.

Clean the connecting rod and the connecting rod cap bearing bore with a lint-free cloth.
Clean all the oil from behind the connecting rod bearing halves.
Install new upper connecting rod bearings into position. Roll the bearing into position so that the lock tang engages the alignment slot. The bearing must fit flush in the connecting rod.
Install the EN 46121 into the connecting rod bolt holes.

Fig 2: Identifying Lower Connecting Rod Bearings
Courtesy of SUZUKI OF AMERICA CORP.
Install new lower connecting rod bearings into position in the connecting rod cap. Roll the bearing into position so that the lock tang engages the alignment slot. The bearings must fit flush with the connecting rod cap.

Reference: PISTON, CONNECTING ROD, AND BEARING INSTALLATION .