Engine Front Cover Installation (Third Design)

Reference: ENGINE FRONT COVER ASSEMBLE .

Special Tool 

EN 46109 Guide Pins 

Fig 1: Identifying Special Tool (EN 46109)

Courtesy of SUZUKI OF AMERICA CORP.

1. Install the 8 mm (0.315 in) guide from the EN 46109 into the cylinder block positions as shown in Fig 1.
   Fig 2: Identifying Cylinder Block Seal

   Courtesy of SUZUKI OF AMERICA CORP.
2. Install the NEW engine front cover to cylinder block seal.
   Fig 3: Placing Bead Of RTV Sealant On Engine Front Cover

   Courtesy of SUZUKI OF AMERICA CORP.
3. Place a 3 mm (0.118 in) bead of RTV sealant, GM P/N 12378521 (Canadian P/N 88901148) or equivalent, on the engine front cover as shown in Fig 3 (1).
   Fig 4: Identifying Engine Front Cover

   Courtesy of SUZUKI OF AMERICA CORP.
4. Place the engine front cover onto the EN 46109 and slide into position.
5. Remove the EN 46109 from the cylinder block.
   Fig 5: Identifying Engine Front Cover Deadener

   Courtesy of SUZUKI OF AMERICA CORP.
6. Install the engine front cover deadener.
   Fig 6: Identifying Engine Front Cover Bolts (1 Of 2)

   Courtesy of SUZUKI OF AMERICA CORP.
   CAUTION: Refer to FASTENER NOTICE .
7. Loosely install the engine front cover bolts to hold the engine front cover deadener into position.
   Fig 7: Identifying Engine Front Cover Bolts (2 Of 2)

   Courtesy of SUZUKI OF AMERICA CORP.
8. Loosely install the remaining engine front cover bolts.
   Fig 8: Tightening Engine Front Cover Bolts

   Courtesy of SUZUKI OF AMERICA CORP.
9. Tighten the engine front cover bolts in the sequence shown in Fig 8 (1-22).

   Tightening torque 

   Tighten the engine front cover bolts in the sequence to 23 N.m (17 lb ft)  .

   Fig 9: Identifying Camshaft Position Actuator Valves

   Courtesy of SUZUKI OF AMERICA CORP.
10. Place the camshaft position actuator valves in position on the front cover.
11. Install the camshaft position actuator valve bolts.

    Tightening torque 

    Tighten the camshaft position actuator valve bolts to 10 N.m (89 lb in)  .

    Fig 10: Identifying Camshaft Position Sensors

    Courtesy of SUZUKI OF AMERICA CORP.
12. Install NEW O-rings on the camshaft position sensor.
13. Place the camshaft position sensors in position on the front cover.
14. Install the camshaft position sensor bolts.

    Tightening torque 

    Tighten the camshaft position sensor bolts to 10 N.m (89 lb in)  .

    Reference: WATER PUMP INSTALLATION .