Camshaft Position Actuator Installation - Right Side Intake (Third Design)

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: CAMSHAFT TIMING DRIVE COMPONENTS CLEANING AND INSPECTION (THIRD DESIGN) .

Fig 1: Identifying Camshaft Position Actuator

Courtesy of SUZUKI OF AMERICA CORP.

Ensure the proper camshaft position actuator is installed. Observe the body of the camshaft position actuator for the "IN" marking (3). The marking is for an intake camshaft position actuator.
Ensure the proper timing mark is used. Observe the outer ring of the camshaft position actuator for the triangle marking (2). The marking is for alignment to the highlighted timing chain link on the right side of the engine.
CAUTION: Refer to TORQUE REACTION AGAINST TIMING DRIVE CHAIN NOTICE .
Use an open wrench on the hex cast into the camshaft in order to prevent camshaft rotation when tightening the camshaft position actuator bolt.

Fig 2: Identifying Camshaft Position Actuator & Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the right intake camshaft position actuator.
CAUTION: Refer to FASTENER NOTICE .
Install the camshaft position actuator bolt.
Tightening torque

Tighten the camshaft position actuator bolt to 58 N.m (43 lb ft) .

Reference: CAMSHAFT POSITION ACTUATOR INSTALLATION - RIGHT SIDE EXHAUST (THIRD DESIGN) .