Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Refer to BRAKE FLUID IRRITANT CAUTION .

CAUTION:

Refer to BRAKE FLUID EFFECTS ON PAINT AND ELECTRICAL COMPONENTS NOTICE .

Fig 1: Identifying Underhood Electrical Center

Courtesy of SUZUKI OF AMERICA CORP.

Remove the underhood electrical center. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT .
Disconnect the electrical connector from the brake fluid level sensor.

Fig 2: Disconnecting Brake Pipes From Master Cylinder
Courtesy of SUZUKI OF AMERICA CORP.
Disconnect the brake pipes from the master cylinder.
NOTE:
Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
Plug the open brake pipe ends.

Fig 3: Identifying Master Cylinder Mounting Nuts (1 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.
Remove master cylinder mounting nuts.
Remove the master cylinder from the vehicle.
Drain the master cylinder reservoir of all brake fluid.