Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Accelerator Pedal Assembly Electrical Connector

Courtesy of SUZUKI OF AMERICA CORP.

Disconnect the accelerator pedal assembly electrical connector.

Fig 2: Identifying Brake Pedal Retaining Clip & Washer
Courtesy of SUZUKI OF AMERICA CORP.
Remove the retaining clip and washer from the brake pedal.
Release the brake booster pushrod from the brake pedal.
Disconnect the brake pedal position sensor electrical connector.

Fig 3: Identifying Brake Pedal Bracket-To-Steering Column Bracket Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Remove the brake pedal bracket-to-steering column bracket bolt.

Fig 4: Identifying Brake Booster Mounting Nuts
Courtesy of SUZUKI OF AMERICA CORP.
Remove the brake booster mounting nuts.
Position the brake booster forward to clear the studs from the front of the dash.

Fig 5: Identifying Steering Column Bracket Cowl Nut
Courtesy of SUZUKI OF AMERICA CORP.
Loosen, but do not remove, the steering column bracket to cowl nut.
While simultaneously disengaging the brake pedal bracket pilot bushings from the foam insulation panel, pull the brake pedal assembly back and toward the center of the vehicle.
Remove the brake pedal assembly from the vehicle.

Fig 6: Identifying Brake Pedal Bracket Bolts (1 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.
Remove the accelerator pedal assembly from the brake pedal bracket. Refer to REMOVAL PROCEDURE .