Manual Shift Detent Lever and Park Pawl Installation

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Park Pawl Pin Spring & Guide Sleeve

Courtesy of SUZUKI OF AMERICA CORP.

Install the park pawl pin spring (704).
Install the park pawl pin spring guide sleeve (705).
CAUTION: Refer to FASTENER NOTICE .
Install the park pawl bolt/screw (706).
Tightening torque

Tighten the park pawl bolt to 10 N.m (89 lb in) .

Fig 2: Identifying Park Pawl Spring Pin
Courtesy of SUZUKI OF AMERICA CORP.
Install the park pawl spring pin (703).

Fig 3: Identifying Park Pawl & Park Pawl Actuator Bracket
Courtesy of SUZUKI OF AMERICA CORP.
Install the park pawl (702) and the park pawl actuator bracket (708).

Fig 4: Identifying Park Pawl Return Spring & Shaft
Courtesy of SUZUKI OF AMERICA CORP.
Install the park pawl return spring (701).
Install the park pawl shaft (700).

Fig 5: Identifying Manual Shift Detent Spring Assembly
Courtesy of SUZUKI OF AMERICA CORP.
Install the manual shift detent spring assembly (711).

Fig 6: Identifying Manual Shift Detent Lever Spring Bolt & Park Pawl Actuator Bracket Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install and hand tighten the 14 mm manual shift detent lever spring bolt (712) and the 16.7 mm park pawl actuator bracket bolt (715).
Tightening torque
- Tighten the 14 mm manual shift detent lever spring bolt (712) to 5 N.m (44 lb in) .
- Tighten the 16.7 mm park pawl actuator bracket bolt (715) to 10 N.m (89 lb in) .
  
  Fig 7: Identifying Park Pawl Actuator Rod
  Courtesy of SUZUKI OF AMERICA CORP.
Install the park pawl actuator rod (709).

Fig 8: Identifying Park Pawl Actuator Rod & Manual Shift Detent Lever Assembly
Courtesy of SUZUKI OF AMERICA CORP.
Install the manual shift detent lever assembly (710).
NOTE: The park pawl actuator rod (709) must be installed with the rod between the case and the manual shift detent lever.
Connect the park pawl actuator rod (709) to the manual shift detent lever assembly (710).

Fig 9: Lifting Manual Shift Detent Lever Spring
Courtesy of SUZUKI OF AMERICA CORP.
Using a screwdriver, lift the manual shift detent lever spring (711) and rotate the manual shift detent lever assembly (710) into position.
Reference: THIRD GEAR BAND APPLY TUBE INSTALLATION .