LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Automatic Transmission) >> Repair Instructions >> Drive Axle Shaft Seal Replacement (Right) >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Place a drain pan under the transaxle to catch any spilled transaxle fluid.
  3. Remove the right front wheel drive shaft. Refer to REMOVAL PROCEDURE and REMOVAL PROCEDURE .
  4. If equipped with an axle seal dust cover, discard it and do not replace it.
    Fig 1: Identifying Right Drive Axle Seal (Right) (1 Of 2)
    G04845991Courtesy of SUZUKI OF AMERICA CORP.
  5. Using the J 45000 remove the right drive axle seal from the transaxle.
  6. Clean the seal bore in the transaxle housing.
scientia non olet · About LEMON Manuals