With SDT
- Turn ignition switch ON.
- Select "P/N POSI SW" in "Data list" mode with SDT. Then check the "P/N POSI SW" signal under the following conditions.SHIFT LEVER POSITION CHART
Position (Shift lever) Known-good signal P or N position (A/T)
Neutral position (M/T)ON Except the above position OFF If NG, go to [Diagnosis Procedure ].
If OK, go to following step.
- Select "Data list" mode with SDT.
- Start engine and warm it up to normal operating temperature.
- Maintain the following conditions for at least 50 consecutive seconds.ENGINE SPEED CHART
ENG SPEED More than 1, 150 RPM (A/T)
More than 1, 400 RPM (M/T)COOLAN TEMP/S More than 70 °C (158 °F) B/FUEL SCHDL 2.0 - 31.8 msec VHCL SPEED SE More than 64 km/h (40 MPH) Shift lever Suitable position - Check 1st trip DTC.
- If 1st trip DTC is detected, go to [Diagnosis Procedure ].