LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake Control System >> Repair Instructions >> Brake Pedal: Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Pedal: Removal and Installation: Removal

WARNING: Do not deform the brake tube.
CAUTION:
  • Do not disassemble the brake pedal assembly.
  • Avoid damage from dropping the brake pedal assembly during handling.
  • Keep the brake pedal assembly away from water.
  1. Remove the lower instrument panel LH. Refer to [INSTRUMENT PANEL ASSEMBLY: REMOVAL AND INSTALLATION ]
  2. Remove the stop lamp switch and ASCD cancel switch from the pedal assembly.
  3. Remove snap pin and clevis pin from the clevis of the brake booster.
  4. Remove the brake pedal assembly bolt.
  5. Remove the pedal assembly nuts and discard, then remove the pedal assembly.
    • Temporarily install the nuts by hand to support the booster.
      CAUTION: Do not reuse the nuts for installation.
scientia non olet · About LEMON Manuals