Pre-Inspection for Diagnostic

Pre-Inspection for Diagnostic

1. INSPECTION START

Turn ignition switch OFF.

NOTE:
Before starting operation check, open front windows.


GO TO 2

2. CHECK SECURITY INDICATOR LAMP

1 Lock doors using keyfob or mechanical key.
2 Check that security indicator lamp illuminates for 30 seconds.

Does the security indicator lamp illuminate?
YES
GO TO 3
NO
Perform diagnosis and repair. Refer to [Vehicle Security System: System Description] Vehicle Security System Description.

3. CHECK ALARM FUNCTION

1 After 30 seconds, security indicator lamp will start to blink.
2 Open any door before unlocking with keyfob or mechanical key.

Does the alarm function properly?
YES
GO TO 4
NO
Check the following.

- The vehicle security system does not phase in alarm mode. Refer to [Vehicle Security System Symptoms: Symptom Table] Vehicle Security System Symptoms Table.
- Alarm (horn and headlamps) does not operate. Refer to [Vehicle Security System Symptoms: Symptom Table] Vehicle Security System Symptoms Table.

4. CHECK ALARM CANCEL OPERATION

Unlock any door using keyfob or mechanical key.

Does the alarm (horn and headlamps) stop?
YES
Inspection End.
NO
Check door lock function. Refer to [Door Lock Function: System Description [Door Lock and Unlock Switch] System Description [Door Lock and Unlock Switch] ].