DTC Confirmation Procedure
WARNING:
If you do not select a suitable route and take proper precautions when performing a road test, an accident can occur.
- Select a level road with no traffic to minimize the risk of accident.
- Perform the test extremely carefully.
- Perform the road test using 2 persons, a driver and an assistant.
NOTE:
- If DTC other than aimed DTC are previously detected in DTC confirmation procedure, be sure to troubleshoot DTC previously detected
- Check that the following condition is satisfied when using this procedure.
- BARO > 75 kPa (0.8 kgf/cm2 , 10.8 psi, 0.75 bar)
- Warm up engine to normal operating temperature.
- Drive vehicle at 50 - 60 km/h (31 - 37 mile/h) for 3 min. (Keep throttle valve opening constantly in this step.)