Tightening Torque Specifications
TIGHTENING TORQUE SPECIFICATIONS
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Tie-rod end nut | 45 | 4.5 | 32.5 |
| Tie-rod end lock nut | 45 | 4.5 | 32.5 |
| Cylinder pipe A | 13 | 1.3 | 9.5 |
| Cylinder pipe B | 13 | 1.3 | 9.5 |
| High pressure pipe | 35 | 3.5 | 25.5 |
| Low pressure return pipe | 35 | 3.5 | 25.5 |
| Steering gear case mounting bolt | 70 | 7.0 | 51.0 |
| P/S pump high pressure pipe union bolt | 65 | 6.6 | 48.0 |
| Steering lower shaft assembly lower joint bolt | 25 | 2.5 | 18.5 |
| Steering lower shaft assembly upper joint bolt | 25 | 2.5 | 18.5 |
| Tie-rod ball nut | 88 | 8.8 | 64.0 |
| P/S pump mounting bolt | 25 | 2.5 | 18.0 |
NOTE:
The specified tightening torque is described in the following.
STEERING GEAR CASE ASSEMBLY COMPONENTS: HYDRAULIC TYPE
P/S HOSE/PIPE COMPONENTS: HYDRAULIC TYPE
P/S PUMP COMPONENTS: HYDRAULIC TYPE
STEERING GEAR CASE ASSEMBLY COMPONENTS: HYDRAULIC TYPE
P/S HOSE/PIPE COMPONENTS: HYDRAULIC TYPE
P/S PUMP COMPONENTS: HYDRAULIC TYPE
Reference:
For the tightening torque of fastener not specified in this section, refer to FASTENERS INFORMATION .