Primary Pulley Speed Sensor Removal and Installation: Installation
WARNING: This page is about a different variant/trim than selected.
Reference: PRIMARY PULLEY SPEED SENSOR AND SECONDARY PULLEY SPEED SENSOR INSPECTION
Reverse removal procedure noting the following.
- Apply CVT fluid to new O-ring of sensor.
- Tighten primary pulley speed sensor bolt to specified torque.
Tightening torque
Primary pulley speed sensor bolt: 5.9 N.m (0.60 kg-m, 4.5 lbf-ft)
- Connect connector and fix wire harness with clamp securely.