LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Kizashi S, 4WD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transaxle (CVT) >> Diagnostic Information and Procedures >> DTC Clearance >> Permanent DTC
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Permanent DTC

  1. Confirm that ignition mode of keyless push start system is in "OFF".
  2. Connect CAN communication OBD generic scan tool or SUZUKI scan tool to DLC. See DTC Check .
  3. Push engine switch to change ignition mode to "ON".
  4. Read detected permanent DTC(s) according to instructions displayed on scan tool and print them or write them down. (Refer to scan tool operator's manual for details.)
  5. Execute all of the following.
    • Perform "DTC Confirmation Procedure" described in each DTC troubleshooting for pending and/or confirmed DTC(s) corresponding to permanent DTC(s) read in Step 4).
    • Run engine for 12 minutes or more.
    • Drive vehicle at more than 45 km/h (28 mile/h) for more than 6 minutes.
    • Run engine at idle for more than 1 minute.
  6. Push engine switch to change ignition mode to "OFF".
  7. Push engine switch to change ignition mode to "ON".
  8. Confirm that permanent DTC is cleared. If permanent DTC is still displayed on scan tool, repeat Step 5) through 6).
scientia non olet · About LEMON Manuals