OCV Inspection

OCV Inspection

1) Remove oil control valve. OCV Removal and Installation
2) Check OCV as follows.
- Check oil control valve for clog or damage.
If check result is not satisfactory, clean or replace OCV.
- Check resistance between terminals of oil control valve connector (1).
If faulty condition is found, replace OCV.

Oil control valve resistance
6.7 - 7.7 ohms at 20 °C (68 °F)





- Connect battery to OCV connector (1) as shown in figure, and check that there is operating sound and that spool valve (2) is properly operating.
If faulty condition is found, replace OCV. OCV Removal and Installation