Tail Lamp: Service and Repair

Rear Combination Light Removal and Installation

Removal

1) Remove trunk side trim. Service and Repair
2) Disconnect rear combination light connector.
3) Remove rear combination light nut (1).
4) Remove rear combination light (2) by pushing it in the direction of arrow.





5) Remove bulb.

Installation

Reverse removal procedure noting the following points.

NOTE:

If the gasket (1) is worn or damaged, water may seep into the vehicle body.

Replace the gasket with a new one if it is deformed or damaged.






- Install rear combination light by pushing it in direction of arrow.
- Tighten rear combination light nuts in order of "1", "2" "3" and "4" to specified torque.

Tightening torque
Rear combination light nut (a): 4.5 Nm (0.46 kgf-m, 3.5 lbf-ft)