C1153

DTC C1153

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

Run engine at idle speed for more than 5 seconds.

DTC Troubleshooting


1. Was "P/S System Check" performed?
YES
Go to Step 2.
NO
Go to P/S System Check P/S System Check.
2. Control module power supply circuit check
Disconnect "E11" connector "G10".
Push engine switch to change ignition mode of keyless push start system to "ON".
Check voltage between "E11-1" terminal and ground.
Is voltage about 12 V (battery voltage)?
YES
Substitute a known-good P/S control module and recheck DTC. Service and Repair
NO
Check generator and battery. Testing and Inspection
/ Testing and Inspection