B1132

DTC B1132

DTC Detecting Condition and Trouble Area






Circuit Diagram










DTC Confirmation Procedure

1) Push engine switch to change ignition mode to "ON".

DTC Troubleshooting


1. Wiper interval adjustment switch power supply circuit check
Confirm that ignition mode of keyless push start system is in "OFF".
Disconnect wiper/washer switch and "G05" connectors.
Check for proper terminal connection to wiper/washer switch and "G05" connectors.
If connections are OK, check the following points.
Resistance between "A1" circuit and ground: infinity
Resistance between "A1" and "A3" circuit terminals at wiper and washer switch connector: infinity
Are they in good condition?
YES
Go to Step 2.
NO
Repair or replace defective wire harness.
2. Wiper and washer switch check
Check wiper and washer switch. Wiper and Washer Switch Inspection
Is it in good condition?
YES
Substitute a known-good BCM and recheck DTC.
NO
Replace wiper and washer switch. Wiper and Washer Switch Removal and Installation