LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Grand Vitara Limited, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Body Electrical Control System) >> Diagnostic Information and Procedure >> Combination Switch System Symptoms: Symptom Table
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Combination Switch System Symptoms: Symptom Table

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform the data list of SDT to check for any malfunctioning item.
  2. Check the malfunction combinations.
    MALFUNCTION COMBINATIONS REFERENCE

    Malfunction item: x
    Data list item Malfunction combination
    TURN SIGNAL R TURN SIGNAL L HI BEAM SW HEADLAMP SW 1 HEADLAMP SW 2 TAIL LAMP SW PASSING SW FR FOG SW FR WIPER HI FR WIPER LOW FR WIPER INT FR WASHER SW INT VOLUME
    x x               x   x   A
          x     x   x   x     B
        x   x               x C
              x             x D
                  x         x E
                    x       x F
                          x x G
                      x x     H
      x     x   x x           I
    x   x x   x               J
    Combinations other than those above K
    All Items L
    If only one item is detected or the item is not applicable to the combinations A to L M
    [a]: TURN SIGNAL R
    [b]: TURN SIGNAL L
    [c]: HI BEAM SW
    [d]: HEADLAMP SW 1
    [e]: HEADLAMP SW 2
    [f]: TAIL LAMP SW
    [g]: PASSING SW
    [h]: FR FOG SW
    [i]: FR WIPER HI
    [j]: FR WIPER LOW
    [k]: FR WIPER INT
    [l]: FR WASHER SW
    [m]: INT VOLUME
  3. Identify the malfunctioning part from the agreed combination and repair or replace the part.
    MALFUNCTION COMBINATION REFERENCE

    Malfunction combination Malfunctioning part Repair or replace
    A Combination switch INPUT 1 circuit Inspect the combination switch input circuit applicable to the malfunctioning part. Refer to [COMBINATION SWITCH INPUT CIRCUIT CHECK ].
    B Combination switch INPUT 2 circuit
    C Combination switch INPUT 3 circuit
    D Combination switch INPUT 4 circuit
    E Combination switch INPUT 5 circuit
    F Combination switch OUTPUT 1 circuit Inspect the combination switch output circuit applicable to the malfunctioning Refer to [COMBINATION SWITCH OUTPUT CIRCUIT CHECK ].
    G Combination switch OUTPUT 2 circuit part.
    H Combination switch OUTPUT 3 circuit
    I Combination switch OUTPUT 4 circuit
    J Combination switch OUTPUT 5 circuit
    K Light and turn signal switch or front wiper and washer switch Refer to [COMBINATION SWITCH CIRCUIT CHECK ].
    L BCM Replace BCM. Refer to [BCM (BODY CONTROL MODULE): REMOVAL AND INSTALLATION ].
    M Light and turn signal switch or front wiper and washer switch Replace the switch that cannot be operated.