LAN System: DTC Check
WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.
If communication signals cannot be transmitted or received among units communicating via CAN communication line, CAN communication-related DTC is displayed on the SDT "DTC check" screen.
NOTE:
The following table shows examples of CAN communication-related DTC. For other DTC, refer to the applicable sections.
DTC DETECTION CONDITION CHART
| DTC | Self-diagnosis item (SDT indication) | DTC detection condition | Inspection/Action | |
|---|---|---|---|---|
| U1000 | CAN COMM CIRCUIT | ECM | When ECM is not transmitting or receiving CAN communication signal of OBD (emission-related diagnosis) for 2 seconds or more. | Start the inspection. Refer to the applicable section of the indicated control unit. |
| Except for ECM | When a control unit (except for ECM) is not transmitting or receiving CAN communication signal for 2 seconds or more. | |||
| U1001 | CAN COMM CIRCUIT | When ECM is not transmitting or receiving CAN communication signal other than OBD (emission-related diagnosis) for 2 seconds or more. | ||
| U1002 | SYSTEM COMM | When a control unit is not transmitting or receiving CAN communication signal for 2 seconds or less. | ||
| U1010 | CONTROL UNIT(CAN) | When an error is detected during the initial diagnosis for CAN controller of each control unit. | Replace the control unit indicating "U1010". | |