Steering Lock Assembly (Ignition Switch) Removal and Installation: Installation

Position oblong hole of steering shaft (2) in the center of hole in steering column assembly (1).

Fig 1: Identifying Steering Shaft And Steering Column Assembly
Courtesy of SUZUKI OF AMERICA CORP.
Turn ignition key to ACC or ON position and install steering lock assembly onto column.
Now turn ignition key to LOCK position and pull it out.
Align hub on lock with oblong hole of steering shaft and rotate shaft to assure that steering shaft is locked.
Tighten new bolts until head of each bolt is broken off.

Fig 2: Identifying Steering Column Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Turn ignition key to ACC or ON position and check to be sure that steering shaft rotates smoothly. Also check for lock operation.
Install steering column. Refer to STEERING COLUMN ASSEMBLY REMOVAL AND INSTALLATION .
(Keyless start model)
If steering lock assembly has replaced, after completing installation, register steering lock unit ID code to keyless start control module as following.
- Immobilizer model:
  Register ignition key transponder code in ECM referring to REGISTRATION OF THE IGNITION KEY .
- Non immobilizer model:
  Register steering lock unit ID code in keyless start control module referring to KEYLESS START REGISTRATION .