LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2011 >> Grand Vitara Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Ventilation System (Component Removal & Installation)) >> Repair Instructions >> Intake Sensor: Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intake Sensor: Removal and Installation: Removal

WARNING: This page is about a different car, the 2011 Suzuki Equator. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front kick plate. Refer to [BODY SIDE TRIM: REMOVAL AND INSTALLATION ]
  2. Remove the lower dash side finisher. Refer to [INSTRUMENT PANEL ASSEMBLY: EXPLODED VIEW ]
  3. Remove the front pillar lower finisher. Refer to [BODY SIDE TRIM: REMOVAL AND INSTALLATION ]
  4. Remove the assist grip handle. Refer to [BODY SIDE TRIM: COMPONENT ].
  5. Remove the front pillar upper finisher. Refer to [BODY SIDE TRIM: REMOVAL AND INSTALLATION ]
  6. Remove the lower glove box. Refer to [INSTRUMENT PANEL ASSEMBLY: EXPLODED VIEW ]
  7. Remove the upper glove box (cluster lid E). Refer to [INSTRUMENT PANEL ASSEMBLY: EXPLODED VIEW ]
  8. Disconnect the intake sensor electrical connector.
    Fig 1: Disconnecting Intake Sensor Electrical Connector
    G06445869Courtesy of SUZUKI OF AMERICA CORP.
    NOTE: The intake sensor is located on the top of the heater and cooling unit assembly next to the A/C evaporator cover.
  9. Twist the intake sensor to remove the intake sensor from the heater and cooling unit assembly.
scientia non olet · About LEMON Manuals